Skip to content

run modules on simulator

Jump to bottom
Github edited this page May 17, 2022 · 1 revision

Set up and start the IoT Edge Simulator

In order to run the modules defined in a deployment configuration (such as config/deployment.amd64.json) on your development machine using the iotedgedev simulator run the following command:

iotedgedev start --setup --file config/deployment.amd64.json

The IoT Edge Hub Simulator starts the containers defined in the IoT edge device manifest in your local machine.

More information
  1. You will see an "IoT Edge Simulator has been started in solution mode." message at the end of the terminal output
  2. Run docker ps, you will see your modules running as well as an edgeHubDev container

Clone this wiki locally