https://www.galayou-store.com/G7

• SoC: Ingenic T23N
• Image Sensor: SC2336
• Wi-Fi Module: Altobeam ATBM6012X
• Flash Chip: NOR 8MB
• Power: 5V DC USB-C

Required Materials:

• Galayou G7 (T23)
• Micro SD card
• USB-TTL adapter (optional, for monitoring progress)
• Small tool for shorting flash pins

1. Download and write U-Boot to the SD card, following this guide:

   wget https://github.com/gtxaspec/u-boot-ingenic/releases/download/uboot-xb1-2024-12-19/u-boot-isvp_t23n_msc0_mmc1bit.bin
   dd if=u-boot-isvp_t23n_msc0_mmc1bit.bin of=/dev/sdX bs=512 seek=34

2. Download the firmware and place it on the SD card:

   wget https://github.com/themactep/thingino-firmware/releases/download/firmware-2024-12-20/thingino-galayou_g7_t23n_atbm6012bx.bin

   • Rename the downloaded file to autoupdate-full.bin
   • Copy it to the root of the SD card

1. Open the camera housing
2. Locate the flash memory chip on the PCB
3. Follow these steps in order:
   • Power off the camera
   • Insert the prepared SD card
   • Locate pins 5-6 on the flash memory chip
   • Short pins 5-6 (using a wire/jumper)
   • Power on the camera
   • Quickly release the short after powering on

• The camera should automatically begin the flashing process
• If using UART, you can monitor the progress
• Wait for the process to complete before powering off

If flashing doesn't start, verify:

• SD card is properly formatted
• Files are named correctly
• Short timing was correct (try again if needed)
• UART connection for monitoring progress